Flexible Rod Elements ("hotflex")
More Information
Rod Heaters, flexible: HotFlex
Hotset offers flexible rod heaters that can be bent into very specific shapes without the need for special bending jigs.
Due to the flexibility of the HotFlex it is now possibleto bend this heating element into three dimensional shapes.
HotFlex has been designed for concentrated heat in specific areas to optimise the overall heating system.
It is extensively used for heating the plastic flow channels on hot runner manifolds and to focus heat in the specific area on the sealing plates used for bonding and cutting plastic.
contact us to discuss your requirements.
NB: Care should be taken when choosing the length of the HotFlex element:
- The element should not protrude out of the groove by more than 20mm on either side
- Exposure of the heated length (ending 30mm from each end) will cause overheating and failure of the element.
- During bending the element will expand by typically 3%
(dependent on shape. See extension factors under technical data) - The groove should be machined deep enough and not be more than 0.1mm oversize.
- The element must be inserted firmly into the groove, avoiding air gaps which will lead to hot spots and possible failure.
Flexible Rod Heaters: Technical Data
Hotflex diameter 8.5:
HotFlex M.25:
Flexible Rod Element Termination
HotSet HotFlex: Ceramic Connector for Flexible Rod Elements
available as stock item: UHSA-YCERCONNEC
Diameter Options
- 8.5± 0.1mm, standard
- 8.0± 0.1mm
- 8.2± 0.1mm
- 6.5± 0.1mm
Extention Factor
Multiply the groove centreline length of each bend by these expansion factors to determine the appropriate HotFlex length: Hotflex Ø 8.5 mm
- Radius R 10.0mm = 0.94
- Radius R 12.5mm = 0.95
- Radius R 15.0mm = 0.95
- Radius R>15.0mm = 0.96
Unheated Zones
min. 30mm / 30mm
Not Bendable Zones
min. 30mm / 30mm
Minimum Bending Radius
R = 10mm (internal)
Other dimensions and product varieties on request.
Contact us to discuss your requirements