Screw Plug Immersion Heaters, water
Stock Code:
SKU: UHRBC

Incoloy-sheath, 10 Watt/cm², 2" Brass fitting

Screw-in immersion heaters are designed for direct contact with water, solvents, oils, process solutions and gases. Immersion heaters are mounted sideways into the vessel, preferably close to the bottom. 


Notes:

*To view images of termination options, click on the magnifying glass icon in the options column header.
Since the elements are fully immersed, virtually 100% energy efficiency is achieved. Special elementsare available for heating of corrosive solutions, highlz viscous oils, high pressure or hazardous areas. Typically a number of U-shaped heating rods are welded to a threaded boss or a flange. The terminations are usually covered by a termination housing.
 

Design criteria:

Medium:

Oil, sugar based liquids and other solutions may degrade if subjected to a high element temperature. This can also lead to carbon build-up on the element, hindering heat transfer and eventually causing element failure. For these liquids a low watts density is advosable.
 
Flammable substances:
 
Fuels, oil and generally combustible substances must be heated with care. The element temperature and the operating temperature of the system must be maintained below the flashpoint to prevent fire or explosion. Ex-rated elements are therefore specially designed and equipped with a thermostat to limit element temperature. In addition, approved temperature- and pressure control equipment must be used.
Immersion Length (mm)150185270280285350350275330400620620
Rating (Watts)10001500150020001000300040003x10003x15003x20003x30003x4000
Power Supply (Volt)230230/400 3ph
Fitting2"Brass
Options 
- terminals exposed

x

x x xxxxxxx
- terminals exposed, with pocket  x xxxx    
- with terminal cover IP40       xxxxx
- with terminal cover IP65       xxxxx
Below is a list of tags that have been applied to this product. Clicking on a tag will display a list of all products with that tag applied.